background image

INSTRUCTION MANUAL

21L21

SAVE THIS INSTRUCTIONS

184600/3 

THIS PRODUCT CONTAINS A RECHARGEABLE LI-ION BATTERY.
THE BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.

WWW.PHENIXLIGHTING.COM

Li-ion

EMERGENCY  POWER  E QUIPMENT
UNIVERSAL MINI INVERTER
PURE SINUSOIDAL AC OUTPUT
OUTPUT VOLTAGE AUTO SETTING EQUAL TO INPUT VOLTAGE
AUTO DIMMING (0-10V) OF CONNECTED LOAD

IMPORTANT SAFEGUARDS

WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

  1.  To prevent electric shock, switch off the mains power supply until installation is complete and AC 
       input power is supplied to this product.

  2.  This product requires an unswitched AC power supply of 120-277V, 50/60Hz.

  3.  Make sure all connections are in accordance with the National or Canadian Electrical code and 
       any local regulations.

  4.  To reduce the risk of electrical shock, disconnect both normal power, emergency power supplies 
       and unit connector of this product before servicing.
 
  5.  For emergency operation of LED, incandescent, fluorescent fixtures and screw-base lamps.

  6.  The product is UL Listed for field installation, and use with grounded, Listed, damp location rated 
      fixtures.

  7.  Use this product in 0°C minimum, 50°C maximum ambient temperatures (Ta). It can provide 
       minimum 90 minutes illumination under the emergency mode.

  8.  This product is suitable for use in dry or damp locations. Do not use outdoors. Do not mount 
       it near gas, heaters, air outlets or other hazardous locations.

  9.  Do not attempt to service the batteries. A sealed, non-maintenance battery is used that is not 
       field replaceable. Contact the manufacturer for information or service. 

10.  The use of accessory equipment not recommended by the manufacturer may cause an unsafe 
       condition and void warranty.
 
11.  Do not use this product for other than intended use.

12.  Installation and service should be performed by qualified service personnel.

13.  This product should be mounted in locations and at heights where it will not readily be subjected 
       to tampering by unauthorized personnel.
       

   

Отзывы: