Phason Three Ventilation Stage Control, Руководство пользователя

Страница: 17 / 52

Phason TVS user manual
Setup parameters
The setup parameters should be programmed when the installation has been completed to configure the
TVS, and then generally the parameters do not need to be reprogrammed. These parameters are different
from the other parameters because they do not have a different setting for each program and cannot be
edited in the normal way. Each setup parameter setting is common to all programs. Follow the
instructions below to change the setup parameters.
When the setup parameters have been programmed, the blank program table in Appendix D should be
filled in with the new settings for future reference.
To edit the setup parameters
Press the
PARM button once to enter the edit mode. If you
wish to edit the setup parameters, you must turn off the
memory protect now. See page 9 to turn off the memory
protection.
Next, press the
PROG and PARM buttons simultaneously
to get to the setup parameters. The Setup parameters can be
adjusted as needed and stored in the same way the normal
parameters can. After the setup parameters have been
changed and stored, press the
RETURN button to return to normal operation.
Programming tips
Scrolling backwards
When viewing or editing the parameters, sometimes it is
helpful to scroll backwards through the parameter list. To
do this, press the
PARM and UP buttons simultaneously.
Instead of the TVS displaying the next parameter on the
list, it will display the previous parameter.
10245506 11