Phason AFX-CONNECT, Руководство по установке

Страница: 12 / 54

What you need to know before installing
12
AutoFlex layout
1
Mounting board: make sure all module boards, incoming power, and the ribbon cable from the communication
controller are properly connected.
2 Incoming power terminal: connect 120/230 VAC, 50/60 Hz power. See page 27.
3 Ground terminals: connect any equipment grounds to these terminals. See page 27.
4
12 VDC output terminal: connect any equipment that requires 12 VDC power, such as iWire radios. You cannot
connect VFDs here.
5 ON/OFF switch: switch the AutoFlex ON or OFF using this switch.
6
Cable trough: route AC power equipment cables through the trough. Route data and signal cables along the inner
walls of the enclosure.
7
Communication controller: make sure the ribbon cable is connected from the communication controller to the
mounting board.
8 Slave cable connection: connect an optional AutoFlex Slave unit here.
9 Alarm relay terminal: If you have an external alarm system, connect it here. See page 25.
10
Display controller: make sure the power supply (top board) is properly connected to the bottom board, and all
cables are properly connected.
11 USB drives: (appearance may vary) make sure the USB drives are properly connected to the USB ports.
12 USB cable: make sure the cable is properly connected from the display controller to the display board.
13 HDMI cable: make sure the cable is properly connected from the controller board to the display board.
13
2
11
6
1 3
10
8
5
4
9
7
12