Step 5
Pinch the self-aligning clamp assembly inside the wall until it contacts the backside of the drywall surface. This will force
the four retaining screws to protrude from the front of the flange. Continue to hold the clamp with one hand and use the
electric screwdriver to tighten the center screw of the flange. Once snug, repeat the procedure on the other clamp
assembly. Using your level, verify the mounting frame is correctly aligned in the opening. Make any necessary
adjustments then tighten the remaining screws until the frame is snug and securely clamping the wallboard. Avoid over-
tightening the screws.
Step 6
If you plan on painting the flange and grill insert the grill into the flange now and paint the assembly. Wait for the paint to
dry and remove the grill. Proceed to step 7.
Step 7
Before installing the back box take your speaker wires and connect them to the terminals on the end of the box. There are
two sets of terminals one is for the Front Channel and the other is for the Center Channel. Use care to properly connect the
+ & - leads correctly, then place the back box in the flange. Make sure the back box is in the correct orientation. There are
two volumes in the back box. The smaller one is for the center channel and in most cases should be mounted closer to the
floor.
Step 8
You are now ready to mount the speaker baffle into the flange. Connect the wires in the box to the corresponding speaker
baffle terminal. Make sure the speaker baffle is in the correct orientation. It will only fit one way.
Step 9
Secure the baffle to the flange with the eight screws you removed in step 3. Hold the baffle in position until you have at
least two screws properly secured.
Step 10
Insert the grill assembly by applying light pressure at each corner of the grill and along the sides until flush with the
flange assembly.
218-2061