REV. 8-5-20 Page 1
Skytech: 7015
This remote control system offers the user a 110-120 VAC powered multi-purpose remote control to be used with AC pow-
ered products such as lamps, heaters, fans, electric fireplaces and lighting from up to 30 feet away. The system operates
on one of 10,000,000 security codes that are programmed into the transmitter at the factory.
MODEL: 7015
INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS
DO NOT ATTEMPT TO INSTALL OR OPERATE
INTRODUCTION
The button transmitter has a green and red LED light ring that
ilimunates when you press and release the top button. Tapping
the transmitter one time, turns the appliance ON, emitting one
green blink. Double tapping the transmitter turns the appliance
OFF, emitting two red blinks.
The receiver plugs directly into a polarized 110-120 VAC
grounded receptacle. Then an AC powered appliance is plugged
directly into the receiver which is controlled by the transmitter
(remote control). In addition the receiver has a red LED indicator
light verifying power to the receiver.
If an extension cord is required, only use a (Model 18SPT-3) cord
consisting with an appropriate temperature rating for the intended
use. Both ends of the extension cord must be grounded and
polarized. An extension cord can be purchased from your
appliance dealer.
The transmitter operates on (1) 3-volt Lithium CR2450
button cell battery (included), capable of a 3 year battery
life. Battery life is calculated at an average of 20
activations per day.
Before using the transmitter, look for a small notch under
the battery cover and slide the cover toward the notch and
lift it off.
Underneath the battery is an insulation tab. Pull the tab out
from underneath the battery.
Note:
Below the area where
the battery is installed is a slide switch that shows 3
different positions. This 3 position switch is not used with
this system. Ensure the switch is in the #1 position and
reinstall the battery cover.
There is a low battery indicator built into the transmitter. A
red LED flash will blink once every 4 second indicating the
battery level is low.
TRANSMITTER
Look for notch
Remove Battery
Cover
UP
CR2450
1
3
2
Tab
CR2450
Battery
