PG Drives Technology SK78814/1, Техническое руководство, Страница: 16 / 24

R-
NET
IOM – I
NSTALLATION
PG D
RIVES
T
ECHNOLOGY
5.3 Output Functions
The IOM can control the four direction outputs in two ways.
• Only one output can be switched at a time.
• Two particular outputs can be switched together, i.e. to give a diagonal movement.
The outputs, Speed Up, Speed Down, and Horn reflect the actual state of these buttons on the Input Device in focus. These
functions enable the use of devices such as PC mouse emulators where the speed up/down keys on the JSM can be configured
to be right/left mouse clicks.
Output Example:
To fit an Environmental Control Module, without a Rebus connector, into a Control System:
•
Set the internal identifier switch to position 5.
•
Connect the IOM to the R-net Control System.
• Connect the Environmental Control Module to the IOM 9 Pin D-type Output connector.
• Turn the Control System and use the Mode Button to move to Mode 5.
The Power Module is factory programmed to accept IOM Output Devices in Modes 5, 6 & 7, when the IOM Internal Identifier
Switch is set to position 5, 6 & 7 respectively. It is therefore possible to connect 3 IOM’s as Output Devices, without having to
adjust the programming parameters of the R-net.
It is possible to fit more Output Devices and to adjust which Modes activate them. Refer to the R-net Technical Manual, SK77981
for details.
5.3.1 Four-way Control
Only one output can be switched at one time. The output direction to joystick x-y data relationship is shown in Figure 1 below.
There is one associated programmable, profiled parameter, Output Switching. See programming section for further details.
5.3.2 Diagonal Control
Two outputs can be switched simultaneously. The output direction to joystick x-y data relationship is shown in Figure 2 below.
Figure 1 Figure 2
SK78814/1 16