PFS GB267, Инструкция по эксплуатации, Страница: 17 / 32

GB267 I01 17
7.3 Peeler blade adjustment
Adjustment of the peeler blade before tensioning on the pipe
The design of the Rotational Peeling Tool 20-125 mm makes it necessary to adjust the feed setting
before mounting it on the pipe. There are only two settings that cover the whole dimension range.
Note that you have set the correct dimension range setting before beginning the scraping procedure.
NO STEP IN THE ADJUSTMENT PROCEDURES REQUIRES MAJOR FORCE!
The adjustment of the peeler blade MUST be done carefully and slowly. There must not be any
major force involved.
The Rotational Peeling Tools are precision instruments.
Proceed carefully and slowly. If you notice that something gets stuck or does not work as
expected, first find solve the issue before using more force than necessary.
Should the feeding block not sit correctly in place and it is tightened despite being not being
adjusted properly, the tool can be severely damaged.
Make sure that the tool is clean. Dirt and sand can lead to the mechanics getting stuck.
Any excessive use of force or failure to comply to the described steps and notes/precautions for the
adjustment of the peeler blade resp. feed is considered as improper use.
The manufacturer is not liable for use of the Rotational Peeling Tool that falls outside its
application scope!
Step Action
1 Understanding the settings
1.1 The following pictures show, what both possible settings for the feed of the peeler blade and the
numbers pointing towards you, when looking at the front of the tool, mean.
Setting for the dimension range 20-63 mm Setting for the dimension range 75-125 mm
1.2 The following steps describe the adjustment.