Safety
Revision 4 | Operating instructions sample cleaner SLN 4
13 | 40
Product disposal (waste legislation)
Material disposal (waste legislation)
Cleaning (cleaning agents and disposal)
Hazardous substances (in Germany, the technical rules for hazardous substances – TRGS 555 apply)
Environmental protection regulations.
Electrical connections
The sample cleaner may only be connected to a correctly-earthed socket with an earth
conductor.
Illumination
intensity
The operator must ensure sufficient and proper intensity of illumination in all the areas
of the machine.
At least 300 lux is expected (maintenance value).
ASR A3.4 is applicable in Germany (Technical rules for workplaces – Artificial lighting).
2.6
General safety instructions
The safety equipment and safety instructions described in these Operating
Instructions must be borne in mind.
1.
Disconnect the device from the mains in case of malfunctioning.
2.
Disconnect the device from mains before starting with the cleaning operation.
3.
Do not let the device get wet during transport, storage, cleaning and operation.
4.
Make sure that you only use the sample cleaner when it is in a defect-free
condition.
5.
Never touch the mains cable with wet hands.
6.
Always use original spare parts and accessories (refer to
chapter 0
and
).
2.7
Safety tests
The following safety tests have been conducted by Pfeuffer GmbH at the plant:
Test and inspection as per DIN EN 60204-1:
Inspection to verify that the electrical equipment complies with the technical documentation.
Continuous connection of protective conductor system
Insulation resistance tests
Voltage tests
Functional tests
The functions of the electric equipment, especially those that relate to safety and safety measures, have
been tested.
2.8
Residual hazards associated with the sample cleaner
The operation primarily takes place in automatic mode.
Pay attention to electrical hazards in case of all tasks that are to be carried out vis-a-vis electrically-
operated components.
Be mindful of crushing hazards when setting up, servicing, repairing and operating the machine.
