Pfeiffer Vacuum HiPace 300 P, Руководство по эксплуатации

Страница: 31 / 64

1
2
3 4
Fig. 17: Connecting the cooling water supply
1 Feed line 3 Cooling water connection
2 Dirt trap 4 Return line
Required tools
● Hexagon wrench (14 WAF)
● Calibrated torque wrench (tightening factor ≤ 1.6)
Connecting a cooling water supply
Requirements:
The customer-side cooling system is closed and depressurized. The provided hose
connections correspond to the turbopump connections.
1. If necessary, use a dirt trap in the feed line.
2. Insert the hoses for the cooling water feed line and return line as far as they will go into respective
connections on the turbopump.
3. Adjust the banjo fittings according to your requirements.
– Tightening torque for the banjo fitting:
3 to 3.5 Nm
5.5 Connecting accessories
Installation and operation of accessories
Pfeiffer Vacuum offers a series of special, compatible accessories for its products.
● Information and ordering options for approved
accessories for hybrid bearing turbo-
pumps can be found online.
Auxiliary connection to electronic drive unit TC 400 and TM 700
The electronic drive unit of the turbopump offers space for the connection of maximum 4
accessory devices. M12 connector sockets with the designation "accessory" are available
for this purpose.
● The accessory connections have been preconfigured at the factory.
● After connecting pre-configured accessory devices, these are immediately ready for
operation according to the factory settings.
● The use of other accessories for turbopumps is possible and requires settings in the
configuration of the electronic drive unit.
● The desired accessory output is configured via RS-485 using Pfeiffer Vacuum display
and control units or a PC.
● For detailed information see the “Electronic drive unit TC 400” or “Electronic drive unit
TC 700” operating instructions.
Installation
31/62