Operating Instructions Quadro LED-TL
08/2019
page 4 / 6
086200010
en
5. Commissioning
5.1 Safety information
DANGER
- Indicates an unusually high-level hazardous situation. Non-compliance with this warning may result
in serious irreversible injury or death.
WARNING
- Indicates an unusually high-level hazardous situation. Non-compliance with this warning may result
in serious, irreversible or fatal injury.
CAUTION
- Indicates a hazardous situation. Non-compliance with this warning may result in minor or moderate
injury.
DANGER
- Danger to life due to electric shock
Voltage-carrying devices and exposed connection cables may cause electric shocks and serious
accidents.
Only trained and authorized electricians may work on electrical connections.
Disconnect all supply lines from mains before installation and secure them against reconnec-
tion. Always ensure absence of voltage.
Wait for the discharge phase of 5 minutes for the electrical components. The device should
only be opened afterwards.
The operating voltage must only be applied when the housing is firmly closed.
WARNING - Danger due to unauthorized use of the devices
Improper use may lead to serious accidents.
Ensure that the connection cable is protected against pulling and twisting during installation.
The devices are only intended for fixed installation.
DANGER - Danger due to damage to the devices
Non-compliance with the information on the type plate can lead to serious accidents.
Always observe the information on the type plate when installing and maintaining the de-
vices.
CAUTION - Risk of injury due to sharp edges or heated components
Wear gloves during any installation, assembly or service/maintenance work.
Perform wiring tasks at a distance from sharp edges, corners and internal components.
CAUTION - Impairment of vision
Avoid constant, direct glances into the activated lights to prevent impairment of vision.
5.2 Assembly and installation
Installation:
Loosen the four cross-head screws in all lenses and re-
move them upwards.
The holes for mounting the housing are then accessible,
for dimensions and the recommended mounting bores
see chapter
Perform the electrical connection in the 1st stage hous-
ing (red lens) as follows:
Operating voltage connection
Connection
of the line
