Operating instructions ABL/ ABS/ WBL/ WBS/ WBL-Ü/ WBS-Ü
06/2021
Page 4 / 6
086200007
en
5. Approvals
(Approvals are valid for marked devices)
DNV GL
TAA00001R1
EAC
6. Commissioning
6.1 Safety information
DANGER
- Danger to life due to electric shock
Voltage-carrying devices and exposed connection cables may cause electric shocks and serious
accidents.
➢
Only trained and authorized electricians may work on electrical connections.
➢
Disconnect all supply lines from mains before installation and secure them against reconnec-
tion. Always ensure absence of voltage.
➢
Wait for the discharge phase of 15 minutes for the electrical components. The unit should only
be opened afterwards.
➢
The operating voltage must only be applied when the housing is firmly closed.
WARNING - Danger due to unauthorized use of the devices
Improper use may lead to serious accidents.
➢
Ensure that the connection cable is protected against pulling and twisting during installation.
The devices are only intended for fixed installation.
DANGER - Danger due to damage to the devices
Non-compliance with the information on the type plate can lead to serious accidents.
➢
Always observe the information on the type plate when installing and maintaining the units.
CAUTION - Risk of injury due to sharp edges or heated components
➢
Wear gloves during any installation, assembly or service/maintenance work.
➢
Perform wiring tasks at a distance from sharp edges, corners and internal components.
CAUTION - Risk of sight impairment
➢
Avoid constant, direct glances into the activated lights to prevent impairment of vision.
Opening/ Closing the housing
Circuit
board
The housing can be lifted up and off by loosening the two Phillips screws at the sides.
