petsafe.com
21
Follow all safety instructions for your power tools. Be sure to always wear your safety goggles.
Cross Hard Surfaces (driveways, sidewalks, etc.)
•
Concrete Driveway or Sidewalk (9C):
Place the boundary wire in a
convenient expansion joint or create a groove using a circular saw and
masonry blade. Place the boundary wire in the groove and cover with an
appropriate waterproofing compound. For best results, brush away dirt or
other debris before patching.
•
Gravel or Dirt Driveway (9D):
Place the boundary wire in a PVC pipe
or water hose to protect the boundary wire before burying.
Step 10: Place the Boundary Flags
The boundary flags are visual reminders for your pet of where the warning zone is located.
1. Place the test light contacts on the contact points. Hold the receiver collar at the height of your pet’s neck (
10A
).
2. Walk towards the warning zone until the receiver collar beeps (
10B
).
3. Place the boundary flag in the ground along the boundary wire (
10C
).
4. Walk back into the pet area until the beeping stops.
5. Repeat this process along the warning zone until it is marked with boundary flags every 10 ft. (
10D
).
Note:
If you cannot hear the beep, refer to the test light instructions in Step 8.
To prevent an unintended correction, after the boundary flags have been placed, be sure to set the static correction on
the receiver collar back to level 1, which is tone only.
9C
9D
10 ft.
Boundary
Wire
Boundary
Wire
10C
10D
10B
10A
