Petsafe PRF-3004XW-20, Руководство по эксплуатации

Страница: 20 / 172

20 petsafe.com
EN
FR
NL
ES
IT
DE
DA
Accessories
To purchase additional accessories for your PetSafe
®
Stubborn Dog In-Ground Fence
™
system, visit our website at
www.petsafe.com to locate a retailer near you and for a listing of Customer Care Centre telephone numbers in your area.
Add-A-Dog
®
Additional Receiver Collar -
Instructions for Use
PIG19-10764
Deluxe UltraLight
™
Add-A-Dog
®
Receiver Collar
This unit has 4 adjustable levels of Correction plus a Tone Only mode.
Prepare the Receiver Collar
There are two sets of Contact Points that can be used on your receiver. Your Receiver Collar comes
with the short Contact Points installed. The longer Contact Points should be used on dogs with long
hair. Tighten the Contact Points using the Test Light Tool (
A ) to one-half turn beyond finger tight.
Check the tightness weekly.
A
To Insert and Remove the Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilizes a replaceable PetSafe
®
battery (RFA-67D-11). This unique battery is
designed to make battery replacement easier and increase water protection.
To insert the battery, align the symbols on the battery (arrow) and Receiver Collar (triangle) (
B ). Use
the edge of the Test Light Tool to turn the battery clockwise until the arrow lines up with the lock
symbol on the housing.
To remove the battery, turn the battery counter-clockwise using the edge of the Test Light Tool (
C
).
B
C
DO NOT attempt to cut into or pry open the battery. Be sure to discard the used battery properly.
Battery life will vary depending on how often your pet tests the system and receives a Static Correction. Check the Receiver
Collar every month to ensure the battery is working properly.
A replacement PetSafe
®
battery (RFA-67D-11) can be found at many retailers. Contact the Customer Care Centre or
visit our web site at www.petsafe.com to locate a retailer near you.
To Set the Static Correction Level
Read all steps before attempting to set the Static Correction Level.
1. Remove the clear plastic cover with the Test Light Tool to expose the Correction
Level Button ( D ).
2. With the battery installed, press the Correction Level Button and release when the
Receiver Indicator Light comes on ( E ).
3. The Receiver Indicator Light will emit a series of flashes representing the Static
Correction Level.
4. Increase the Static Correction Level by pressing and releasing the Correction Level
Button within 5 seconds of the previous series of flashes.
5. After setting the Static Correction Level, replace the cover to protect the Correction
Level Button.
D
E
The Static Correction levels increase in strength from 1 to 5. Pushing the Correction Level Button while the Receiver Collar
is on level 5 will cause the Receiver Collar to revert to Level 1. Refer to the Function and Response Table to choose the Static
Correction level that best fits your pet.
The Receiver Collar is equipped to automatically increase the level of Static Correction the longer your pet remains in the
Static Correction Zone if the collar is set at level 2 or above.
The Receiver LED Indicator Light acts as a low battery indicator, flashing every 4 to 5 seconds when replacement is required.