18
+1 (800) 732-2677
petsafe.com 19
The receiver collar
has to be held on top
of the boundary wire
to activate.
• Replace battery.
• Adjust boundary width control knob clockwise to
increase the distance from the boundary wire that
the receiver collar activates. Verify the boundary
control switch is placed at the proper setting
according to the amount of boundary wire used.
• If the receiver collar still has to be held on top
of the boundary wire, refer to Stubborn Dog
In-Ground Fence
™
system product manual.
The receiver collar
activates inside the
house.
• Turn the boundary width control knob
counterclockwise to decrease the distance from the
boundary wire that the receiver collar activates.
• Make sure the boundary wire is not running within
15 ft. of the house. The signal can transmit through
the walls of your house.
• Make sure the boundary wires are twisted from the
boundary to the fence transmitter.
The receiver
indicator light is
flashing every 4 to 5
seconds and I have
just installed a new
battery.
• To reset the low battery indicator, remove the
battery from the receiver collar. Discharge all power
by holding the correction level button down until
the light is no longer illuminated. Reinstall battery.
Additional Information
• The system should only be used with healthy pets. Contact your
veterinarian if you have concerns about the medical condition of your
pet (medication, pregnant, heart conditions, etc.).
• The PetSafe
®
Stubborn Dog In-Ground Fence
™
system is for residential
use only.
• The static correction will get your pet’s attention, but will not cause
harm. It is designed to startle, not to punish.
• Test the receiver collar at least once a month to verify that it is
functioning properly. Check that it activates at the boundary wire.
Battery life depends upon how often the receiver collar is activated.
• Remove the receiver collar from your pet when indoors for the comfort
of your pet.
• Never leave the receiver collar on your pet for more than
12 consecutive hours.
