9
REASSEMBLY OF YOUR FOUNTAIN
3) Take a new filter and rinse under cold water to remove any excess
charcoal dust. Insert the filter into the housing and make sure the
black side is facing the pump (Fig. 16a & 16b).
4) Reattach the stainless steel ramp by pressing back on the tab
located directly underneath the spout. While holding the tab
back, slide the ramp into the opening and release the tab once in
place (Fig. 9, Page 6).
Do not attach the ramp without the tab
depressed, this will cause the tab to become locked into the wrong
position and you will risk breaking this locking tab.
5) Replace the housing by lowering straight down over the pump. Be
sure the housing connects with the guide holes on the rim of the
bowl (Fig. 5, Page 4). Push down to lock it in place.
6) Assemble the two spout pieces. Press the two spout pieces together
by aligning the top piece with the groove on the bottom piece (Fig.
17a). With the spout pieces together, press the spout into the
opening on top of the housing until in locks in place (Fig. 17b).
Fig. 17a
Fig. 17b
Fig. 16b
Filter Slots
Fig. 16a
7) Place the fountain in a desired location.
If placing on carpet,
tile or wood flooring, use a protective mat or other durable,
water resistant surface. This will help protect your floor from any
splashing or spills caused by your pet.
