Petsafe Deluxe In-Ground Radio Fence, Руководство по эксплуатации и обучению

Страница: 13 / 24

www.petsafe.net 13
Step
8
Place the Boundary Flags
The Boundary Flags are visual reminders for
your pet of where the Warning Zone is located.
1. Hold the Receiver Collar at your pet’s neck
height.
2. Walk towards the Warning Zone until the
Receiver Collar beeps ( 8A ).
3. Place a Boundary Flag in the ground ( 8B ).
4. Walk back into the Pet Area until the beeping
stops.
5. Repeat this process around the Warning
Zone until it is marked with Boundary Flags
every 10 feet.
Note: If you cannot hear the beep, see the Test Light
Instructions in Step 6.
8A 8B
__________________________________________________
Fit the Receiver Collar
Important: The proper fit and placement of your Receiver Collar is important for
effective training. The Contact Points must have direct contact with your pet’s skin
on the underside of his neck.
To assure a proper fit, please follow these steps:
1. Make sure that the battery is not installed in the Receiver Collar.
9A
2. Start with your pet standing comfortably ( 9A ).
3. To make it easier to hear the warning beep, place the
Receiver Collar on your pet with the logo side of Receiver
facing up.
4. Center the Contact Points underneath your pet’s neck,
touching the skin. If your pet has a long or thick coat, use
the enclosed long Contact Points to reach through the
hair.
Note: It is sometimes necessary to trim the hair around the
Contact Points to make sure that contact is consistent.
5. Check the tightness of the Receiver Collar by inserting one
finger between the end of a Contact Point and your pet’s
neck. The fit should be snug but not constricting (
9B ).
6. Allow your pet to wear the collar for several minutes then
9B
recheck the fit. Check the fit again as your pet becomes more
comfortable with the Receiver Collar.
7. Trim the collar as follows ( 9C ):
a. Mark the desired length of the Receiver Collar with a pen.
Allow for growth if your pet is young or grows a thick winter
coat.
b. Remove the Receiver Collar from your pet and cut off the
excess.
c. Before placing the Receiver Collar back onto your pet, seal
9C
the edge of the cut collar by applying a flame along the frayed edge.
Important: For comfort, safety and effectiveness of product, please ensure the following:
• During the fi rst 2 weeks of training, do not use the training device on your pet without direct
supervision.
• Check the fi t to prevent excessive pressure by being able to insert one fi nger between the Contact Point
and your pet’s skin.
• Your pet must be carefully examined daily for any signs of a rash or sore.
• If a rash or sore is observed, discontinue the use of the Receiver Collar for a few days.
• If the condition persists beyond 48 hours, see your veterinarian.
Step
9