Permobil Stander, Руководство по обслуживанию, Страница: 17 / 47

18
Adjustments
Leg rest extension
See the adjustment dependencies diagram on
page 6.
When the seat is raised from the sitting to the
standing position, the leg rest becomes longer in
order to improve the comfort of the user. The leg
rest's extension can be set to three different
positions. It is set by moving the roller over which
the leg rest's strap runs. The roller is mounted
under the seat, behind the leg rest, see Fig. 33.
1. Unscrew and remove the screw holding the
roller, see Fig. 33.
2. Loosen the two screws holding the locking
jamb to the leg rest's belt. The locking jamb is
located behind the leg rest under the middle
of the seat, see Fig. 34.
3. Move the roller to the desired position. In
order to increase the extension of the leg rest,
move the roller downwards. In order to
decrease the extension of the leg rest, move
the roller upwards.
4. Insert and screw back in the screw holding the
roller, see Fig. 33.
5. With the seat in the sitting position, push the
leg rest up to its highest position, slide it along
the belt.
Fig. 35. For chairs without stand-up driving, the
supporting frame can be adjusted once the
two screws have been loosened.
Fig. 33. The extension of the leg rest is
adjusted by moving the roller.
1. Adjust the foot plate in the sitting position so
that it is suitable for the user according to the
instructions on pages 14-15.
For chairs equipped for stand-up driving, go
directly to point 3.
Fig. 34. The lock for the leg rest's belt is located
on the rear of the leg rest.
The leg rest must be pushed up to its uppermost
position. Any other position might lead to damage to the
seat or injury to the users.

NOTE
6. Tighten the belt's locking jamb again.
Sensor - Stand function
See the adjustment dependencies diagram on
page 6.
It is very important that the limit position breaker
on the seat lift be adjusted so that the wheel
under the foot plate hits the floor at the correct
angle using the stand function.
Incorrect adjustment can cause an increased risk of
tipping as well as damage to the leg rest. Note that all
adjustments must be performed on a level substrate.
In order to obtain a good result, the user should
sit/stand in the chair while the adjustment is being
performed.

WARNING