PerkinElmer Lambda XLS, Руководство пользователя

Страница: 10 / 90

10 . Lambda XLS/XLS+ User's Guide
General Safety
The Lambda Bio/XLS instruments conform to the requirements of the Low Voltage Directive
2006/95/EC, EMC Directive 2004/108/EC and the IVD Directive 98/79/EC.
Standards to which conformity is declared:
•
EN 61010-1 Safety requirements for electrical equipment for measurement, control and
laboratory use.
•
EN 61010-2-101 Particular requirements for IVD medical equipment.
• BS EN 591 Instruction for use for in vitro diagnostic instruments for professional use.
• BS EN 13612 Performance evaluation of in vitro diagnostic medical devices.
• EN 61326-2.3 Electromagnetic compatibility – generic emission standard Electrical
equipment for measurement, control and laboratory use.
•
EN 61326 Electromagnetic compatibility – generic emission standard Electrical
equipment for measurement, control and laboratory use. Classified as Class B for
conducted and radiated emissions.
The Lambda Bio/XLS complies with the following environmental legislation regarding the
restriction of the use of certain hazardous substances:
• Europe: EU directive 2002/95/EC (RoHS Directive).
•
China: Administration on the Control of Pollution Caused by Electronic Information
Products No 39.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical
and Electronic Equipment (WEEE). See the Lambda Bio/XLS Safety Manual (L6050014) for
more information.
There are a number of warning labels and symbols on your instrument. These are there to
inform you where potential danger exists or particular caution is required. Before
commencing installation, please take time to familiarize yourself with these symbols and their
meaning.
This instrument is subject to the following hazards:
The UV source contained within the unit generates a light beam that passes
through the sample chamber during sample measurements. Under normal use,
this beam is contained within the unit and no UV radiation is emitted from the
system. However, care should be taken that no reflective items are placed in
the beam during sample measurements so that the beam is reflected out of
the system. Also, the sample holder should be removed for cleaning only when
the power is disconnected from the instrument. Prolonged exposure to the
beam may cause permanent eye damage.