3. Loop the strap through the "D" ring and
maneuver it back down through the
same hole (see Figure 3).
4. Once the strap has been pulled
tight, secure the light using the
provided Velcro
®
.
5.
To operate:
To turn the headlamp
on and off, push the button switch
on the back of the headlamp housing.
6. The headlight can be aimed by rotating the assembly up or
down. After obtaining proper beam adjustment, securely tighten
the clamp bolt.
7. Your ViewPoint™ Single Pro comes with a 12-watt spot beam bulb. Other
bulbs are available to customize your light to the type of riding that you
do. Refer to the section on changing bulbs. Please note that using a bulb
of higher wattage will reduce the run time of your light.
NOTE: The high wattage bulb causes the aluminum housing to get very hot
when the light is in use. Therefore, DO NOT TOUCH ALUMINUM HOUSING
WHILE THE LIGHT IS IN USE. Please use caution to avoid burning yourself.
For optimum durability, your ViewPoint
™
light should be mounted in such
a way as to keep air flowing over the system.
Battery Charging
The ViewPoint
™
Pro Nickel Metal Hydride (NiMH) battery must be recharged using
only
the 7.25 V, 500mA NiMH compatible battery charger included with your
light. Use only this recharger for NiMH batteries.
Do not use any other charger.
It
is extremely important that you always store your battery fully charged.
For the longest battery life, you should always recharge immediately after each
use.
Never use a lead acid compatible charger on a NiMH battery.
To guarantee a full recharge, leave the battery plugged in for 10 hours.
Your ViewPoint
™
has a trickle charge feature which allows it to be left on
recharge indefinitely, without harm.
Also available for your ViewPoint
™
System
40-0322 NiMH 4.0 Ah (Compact) battery
00-2365 12 Watt flood bulb (30º beam)
00-8152 12 Watt spot bulb (10º beam)
40-0026 15 Watt intermediate bulb (20º beam)
00-8154 20 Watt flood bulb (30º beam)
Fig. 2
Fig. 3
Fig. 1
