OPERATION CONT.
This tool is equipped with the safety and does not operate unless the safety is depressed.
The methods of operation to drive nails with this tool is single actuation mechanism.
1. Position the nail outlet on the workpiece with finger off the trigger.
2. Depress the safety firmly until it is completely depressed.
3. Pull the trigger to drive a nail.
4. Remove finger from the trigger.
To continue nailing a separate location, move the tool along the wood, repeating steps
(2-4) as required.
NOTE: Always handle nails and package carefully. If nails are dropped, collating bent may
be broken, which will cause mis-feeding and jamming.
After nailing:
1. Disconnect air hose from the tool.
2. Remove all nails from the tool.
3. Supply 5-10 drops of pneumatic tool lubricant into the air plug on the tool.
4. Open the petcock on the air compressor tank to drain any moisture.
WARNING:
Do not use a frozen tool. Allow tool to thaw before using. Moisture frozen
in the tool may impede internal components resulting in the risk of injury and/or tool
damage.
When using the tool in cold conditions the tool will cycle slower than usual while driving
the first nails. The cycle rate will increase as the tool warms up. Keep tool warm to avoid
reduced cycle rate.
Adjusting Nailing Depth
WARNING:
Disconnect the tool from the air source before making adjustments. Such
precautionary safety measures reduce the risk or unintentional tool operation.
1. Disconnect tool from air supply.
2. Remove nails from the tool.
3. Adjust tool driving depth:
• To reduce the nail depth , turn the adjustment knob counter clockwise.
• To drive the nail deeper, turn the adjustment knob clockwise.
4. Reload nails as described in the "Nail Loading" sectionof this manual.
5. Reconnect air supply.
To reduce the nail depth , turn the
adjustment knob counter clockwise.
To drive the nail deeper, turn
the adjustment knob clockwise.
Flush
Flush
Too
Deep
Too
Shallow
9