Performance Motion Devices PR8358120, Руководство пользователя

Страница: 94 / 103

Interconnect Module
94
Prodigy/CME PC/104 User’s Guide
5
Figure 5-3:
DC-1000
location of
components
The names and descriptions of the main components of the DC-1000 are detailed in the following table:
5.3.2 DC-1000 Connections
The pinouts for connector DC4 are outlined in the following table:
Label Name Description
DC1 Parallel connector This socket connects to the parallel input connector of the Prodigy/CME PC/104
card.
D1, D2 Mounting holes These holes (2) are in direct alignment with the mounting holes on the Prodigy/CME
PC/104 card, and are used for the mounting screws and stand-offs.
JP1 Jumper This jumper selects either 5V or 12V supply voltage. 5V DC is the default setting.
DC4 Encoder connector The encoders are connected to this pin block.
PC1 Power connector Use this pin block to connect a small Molex connector for DC power.
SW1 DIP switches This block of DIP switches is used to set encoder resolution for each axis.
DC7 PLD This is the processor for the DC-1000.
IDC Pin No. Description Axis
1 +5 or +12 VDC to Encoder 1
2 Clock 1+ 1
3 Clock 1- 1
4 GND 1
5 DIN 1+ 1
6 DIN 1- 1
7 +5 or +12 VDC to Encoder 2
8 Clock 2+ 2
9 Clock 2- 2
10 GND 2
11 DIN 2+ 2
12 DIN 2- 2
13 No connection
14 No connection
DC1
D2
D1
JP1
DC4
PC1
SW1
DC7
1
2
34
56
78 On
[69.0]
2.72
[59.0]
2.32
KEY:
[mm]
inch