Installation and Operation Manual for
Perenio®
Joule Eco Smart Heater
Document version: 1.1.0
©Perenio IoT spol s r.o. All rights reserved
Page
20
of
55
2.1 First Installation and Configuration
To ensure proper installation and operation of the Eco Smart Heater, follow the steps
below:
1.
Unpack
the device (See par. 2.1.1), install
it in the desired location (
See par.
2.1.2 or par. 2.1.3)
and
connect to the source of power
(220V
) using the power
cable.
2.
If necessary, activate the device in the mobile app (See par. 2.5 or par. 2.6).
3.
Operate the device manually, or remotely via the mobile app (See par. 2.5 or
par. 2.6) and/or voice assistants (See par. 1.6).
IMPORTANT!
Upon the initial activation in the mobile app, the Eco Smart Heater
firmware update process may be started (In this case, the notification will be
displayed in the control panel of the device and in the
“
Event History
”
tab).
Do not
disconnect the device from the mains until the update process is
completed!
Also, do not disconnect the device from the mains for
5 minutes
after resetting
it to factory settings.
2.1.1 Unpacking and Preparing for Installation
1.
Unpack the device carefully and remove the accessories.
2.
Arrange the device on a clean, horizontal surface with the heat-radiant panel
facing downwards.
3.
Wipe both sides of the heat-radiant panel with a water-dampened cloth, and
then with a dry, streak-free cloth. Make sure that the device is free from dust
and dirt.
4.
Prepare the device installation area.
5.
Mount the device in the desired area as per selected installation option (See
par. 2.1.2 or par. 2.1.3).
NOTE.
Do not use the device at ambient
temperatures of 0°C or lower
, as it will
initiate an error, and the device will not be switched on.
Содержание Joule Eco Smart Heater
Страница 2: ......