Installation and Operation Manual for the
PERENIO IONIC
SHIELD™
Cold Plasma Emitter
Document version: 1.0.8
© Perenio IoT spol s r.o. All rights reserved
Page
24
of
35
•
Ability to recharge the Device as needed;
•
Flat and stable surface of installation.
2.1 Preparation for Work
1.
Unpack the Device
and accessories.
2.
Remove the sticker from the top of the capsule using a special reel (See picture
below).
Figure 6
–
View of the sticker atop the capsule
3.
Make sure that the capsule is tightened properly. Fix it by pressing it on top (See
Figure 7-a) and turning clockwise in the Device casing so that the marks are
aligned in the “CLOSED” position (See Figure 7
-c).
7-a
–
pressing on top
7-b
–
“OPEN” position
7-c
–
“CLOSED” position
Figure 7
–
Tightening the capsule
Содержание IONIC SHIELD PEWOW01COV
Страница 2: ......
