TL62000
V. 01
–
30/09/2016
3
©Velleman nv
USER MANUAL
1.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should
be taken to a specialized company for recycling. This device should be returned to your distributor or to
a local recycling service. Respect the local environmental rules.
If
in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel. Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, do not install or use it and contact your dealer.
2.
Safety Instructions
This device can be used by children aged from 8 years and above, and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning the use of the device in a safe way and understand the hazards
involved. Children shall not play with the device. Cleaning and user maintenance shall not be made by
children without supervision.
Do not use the device when damage to housing or cables is noticed. Do not attempt to service the
device yourself but contact an authorised dealer.
3.
General Guidelines
Refer to the
Velleman® Service and Quality Warranty
on the last pages of this manual.
Protect this device from shocks and abuse. Avoid brute force when operating the device.
Familiarise yourself with the functions of the device before actually using it.
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
Keep this manual for future reference.
4.
Mounting
For the best results, mount the lift assemblies so the hooks are directly above the seat and handlebar.
If you wish, you can mount the entire assembly to a board and then mount the board to ceiling joists.
1.
Measure the distance between the handlebars and the back of the seat. This is where the hooks will attach
to the bike. These measurements will be transferred to the ceiling or a board.
2.
Locate a ceiling joist. If your ceiling is covered with drywall, look for nail props, irregularities and fixtures.
These are clues to locating joists. Use a small nail or screwdriver to run a pilot hole into the ceiling to
ensure that you have located a joist. Once a joist is located, measure from wall to the joist. Transfer your
seat/handlebar measurement along the joist so the lift attachments line up. If you are planning to mount
the lift assemblies in the opposite direction of the joists, you will need to mount the lift assemblies to a
board and attach the board to two joists.
3.
Tie a double knot on the rope end. Feed the rest of rope through square hole on lift assembly. Continue
threading the rope through the lift assembly pulleys and hook assembly pulleys.
4.
Using the wood screws provided, mount each of the lift assemblies (3 screws each) to the ceiling ensuring
that the hooks line up with your seat/handlebar measurements.
5.
Use the remaining 2 wood screws to mount the rope cleat to the wall. Again, you will need to find a stud to
mount the cleat. Use wall anchors if necessary. Do not cut the rope. Use cleat for excess.
Содержание TL62000
Страница 2: ...TL62000 V 01 30 09 2016 2 Velleman nv ...
