PERCo RTD-03S, Руководство по эксплуатации

Страница: 11 / 26

Operation manual
10
At the AC mains failure the transistor is closed;
•
«Bat failure C» – built-in SPS failure (contacts “Pwr failure C” and “Pwr failure E” –
collector (+) and emitter (-) of the galvanic decoupling circuit correspondingly).
At the built-in SPS failure (the battery discharge up to 22.5V) the transistor is closed;
•
«Pass Sensor» – the data of the infrared intrusion detector. This data is transmitted to the
ACS from the intrusion detector (if installed). Relay output (contacts Pass Sensor 1 and Pass
Sensor 2 ).
The CU output cascades, generating the signals «Pass R» , «Pass L» , «Pass Sensor», «Pwr
failure» and «Bat failure», have the galvanic decoupling.
a) Control elements of an external device a normally open relay contact
b) Control elements of an external device a circuit with open-collector output
Figure 5. Control elements in the ACS
To generate the signals «Pass R» , «Pass L» and «Pass Sensor» the CU output cascades have
the relay output circuits with the following signal characteristics:
the maximum voltage.............................................................................................. max 50 V
the maximum current ......................................................................................... max 200 mA
To generate the signals
«Pwr failure»
and
«Bat failure»
the CU output cascades have the
optoelectronic decoupling's with the following signal characteristics:
output transistor type ..................................................................................................... n-p-n
insulation voltage ......................................................................................................... 5,3 kV
the maximum collector-emitter voltage .................................................................... max 25V
the maximum current ........................................................................................... max 50 mA