Installation
2
0
1
7
-0
5
19
Mounting the adapter directly on a field device
1. Remove the blind plug from the cable entry at the side of the adapter.
2. Push a Viton gasket on either side of the connection adapter supplied with the adapter.
3. Using a spanner, screw the connection adapter tightly into the cable entry of the field drive
(torque 5 Nm + 1 Nm).
4. Loosen the counternut on the adapter.
5. Insert the other end of the connection adapter into the cable entry of the adapter and screw
tight (torque 5 Nm + 1 Nm).
6. Align the adapter so that the antenna is vertical.
7. With the cable entry nut held with a spanner, tighten the counternut (torque 7 Nm).
3.2.2
Mounting to a Wall
Figure 3.7
Mounting to a wall with mounting bracket
As an addition to the tools already listed (see chapter 3.2.1), an M4 Allen key/bit is required to
tighten the mounting bracket screws.
1
Counternut
2
Cable entry
3
Connection adapter
Tip
Loosening the counternut allows the adapter to be screwed into position without the need to
turn the adapter housing.
1
Mounting bracket
2
Blind plug
1
2