AS-Interface
Command Interface
Subject to reasonable modifications due to technical advances.
Copyright Fuchs, Printed in Germany
Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Is
s
ue dat
e -
12.
8.
2007
92
10.3.5.6
Get extended permanent configuration (GET_PCD)
This call reads the following configuration data (configured data) of an addressed
AS-i slave stored on the EEPROM of the AS-i master:
• I/O configuration
• ID code
• Extended ID1 code
• Extended ID2 code
The configuration data are specified by the manufacturer of the AS-i slave.
Meaning of bit B:
B = 0 Single AS-i slave or A-slave
B = 1 B-slave
10.3.5.7
Set list of projected slaves (SET_LPS and SET_LPS_R6 (6Bh))
The command
SET_LPS_R6 (6Bh)
differs from the command
SET-LPs
in:
• no empty byte (3)
• half so long LPS list
With the bit 2
5
is selected if the upper (=1) or lower (=0) part of the LCS is read.
With this call, the list of configured AS-i slaves is transferred for permanent storage
in the EEPROM of the master.
When this command is executed, the AS-i master changes to the offline phase and
then changes back to the normal mode (warm restart).
This command can only be executed in the configuration mode.
Request
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
1
26
16
2
T
–
circuit
3
–
B
slave address
Response
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
1
26
16
2
T
result
3
xID2
xID1
4
ID
I0
Request (if O
≡
0)
byte
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
1
29
16
2
T
0
circuit
3
00
16
