VAA-2E-G4-SN
Operating the modules
Dat
e
of
is
sue
20.
05.
2005
23
Subject to reasonable modifications due to technical advances.
Copyright Fuchs, Printed in Germany
Fuchs Group • Tel.: G49 621 776-0 • USA +1 330 4253555 • Sin65 67799091 • Internet http://www.pepperl-fuchs.com
7
Operating the modules
7.1
Installation
7.2
Addressing of the modules
The addressing of the AS-Interface slave is performed with the aid of a
manual addressing device or with an AS-Interface master. When using
the manual addressing device, the AS-Interface slave is simply plugged
into this device and then the adress can be set. Addresses from 1 to 31
can be assigned. The state as supplied is address 0.
7.3
Operation of the AS-Interface safety input modules
The safety function of the slave is also determined by the monitor. The
corresponding documentation must be observed.
In order to achieve IP67 the housing must be screwed with
the lower section in a way that it lies evenly on the
supporting points on the lower section.
Attention
Put the screw fittings on the sensor/actuator cable.
Cabel bended
Connect the den insulated sensor/actuator cable in sequence
3, 4, 2, 1.
