Pepperl+Fuchs OMR150M-R1000 Series, Руководство пользователя

Страница: 16 / 29

2
0
2
1
-0
9
16
Distance Sensors
Installation
3.
Align the laser beam as centrally as possible by turning the tilt adjustment screw with a
hexagon socket wrench. First set the Y axis and then the Z axis.
• Y-axis:
To move the laser beam to the left on the reflector, turn the adjusting screw clockwise.
To move the laser beam to the right on the reflector, turn the adjusting screw counterclock-
wise.
• Z-axis:
To move the laser beam down on the reflector, turn the adjusting screw clockwise.
To move the laser beam up on the reflector, turn the adjusting screw counterclockwise.
4.
Gradually increase the distance of the reflector and repeat the last step.
5.
To prevent accidental movement of the device during operation, tighten the two M5 locking
screws on the Y-axis and the two M5 locking screws on the Z-axis.
The tightening torque for the locking screws must not exceed 4.4 Nm.
5.4 Reflector Selection
5.5 Reflector Arrangement
Figure 5.4 Reflector size
Reflector 250 mm x
250 mm Reflector 500 mm x
500 mm Reflector 1000 mm x
1000 mm
OMR50M-R1000 Yes Yes Yes
OMR150M-R1000 No Yes Yes
Table 5.1 Reflector Selection
Beam divergence
Beam diameter: appr. 25 cm appr. 50 cm appr. 75 cm
0 100 m 150 m 50 m
R1000