Level Probe LGC2
Basic Safety Instructions
2017
-0
2
13
2
Basic Safety Instructions
2.1
Requirements for the Personnel
The personnel for installation, commissioning, diagnostics and maintenance must fulfill the
following requirements:
• Trained, qualified specialists must have a relevant qualification for this specific function
and task
• Are authorized by the plant owner/operator
• Are familiar with federal/national regulations
• Before beginning work, the specialist staff must have read and understood the instructions
in the manual and supplementary documentation as well as in the certificates (depending
on the application)
• Following instructions and basic conditions.
The operating personnel must fulfill the following requirements:
• Being instructed and authorized according to the requirements of the task by the facility's
owner-operator.
• Following the instructions in these manual.
2.2
Intended Use
2.2.1
Application and Media
The device is a hydrostatic pressure sensor for measuring the level of fresh water, wastewater
and salt water. The temperature is measured simultaneously in the case of sensor versions
with a Pt100 resistance thermometer. An optional temperature head transmitter converts the
Pt100 signal into a 4 to 20 mA signal.
2.2.2
Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
Verification for borderline cases:
For special fluids and fluids for cleaning, Fuchs is glad to provide assistance in
verifying the corrosion resistance of fluid-wetted materials, but does not accept any warranty or
liability.
2.3
Workplace Safety
For work on and with the device:
• Wear the required personal protective equipment according to federal/national regulations.
• Switch off the supply voltage before connecting the device.
2.4
Operational Safety
Risk of injury.
• Operate the device in proper technical condition and fail-safe condition only.
• The operator is responsible for interference-free operation of the device.
