peplink Pepwave DCS-RUG, Руководство пользователя

Страница: 55 / 57

Restoration of Factory Defaults
To restore the factory default settings on a Pepwave Device Connector Rugged,
follow the steps below:
1. Locate the reset button on the front or back panel of the Pepwave Device
Connector Rugged router.
2. With a paperclip, press and keep the reset button pressed.
Note: There is a dual function to the reset button.
Hold for 5-10 seconds for admin password reset (
​
Note: The LED status light blinks in
RED 2 times and release the button,
​
green status light starts blinking)
Hold for approximately 20 seconds for factory reset (
​
Note: The LED status light blinks
in RED 3 times and release the button,
​
all WAN/LAN port lights start blinking)
After the Pepwave Device Connector Rugged finishes rebooting, the factory default
settings will be restored.
Important Note
All previous configurations and bandwidth usage data will be lost after restoring factory
default settings. Regular backup of configuration settings is strongly recommended.