Hardware Setup
15
J24 – HDD LED Connectors
Attach the cable of hard disk drive LEDs to this connector. The LED
lights when an HDD is active.
IDE1/IDE2 – On-board Primary/Secondary IDE HDD
Connectors
Attach cables of hard disk drives to these connectors.
CN5 – IR Connector
Attach a 5-pin infrared device cable to this connector for enabling the
infrared transfer function. This mainboard meets the specification of
ASKIAR and HPSIR.
CN2 – PS/2 Keyboard Connector
A PS/2 keyboard connector is located at the rear of the board. Plug a 6-
pin male PS/2 keyboard connector to this connector.
J17 – Keylock & Power LED Connector
J17 is a connector for a lock that may be installed on the system case for
enabling or disabling the keyboard. J17 also attaches to the caseÕs Power
LED. (Pin 1, 3 for power LED and pin 4, 5 for keylock.)
LED1 — ATX Power Supply Indication LED
LED lights on when ATX power supply is working. DonÕt install any
add-in card when the LED light is on.
CN1 – PS/2 Mouse Connector
Attach 6-pin male PS/2 mouse connector to this connector.
PRT – Parallel Port Connector
Attach parallel port cable to this connector.
JP50 (PW2) — ATX Power Supply On/Off Switch Connector
Attach a two-pin switch to this connector for turning the ATX power
supply on/off.
