Pentair HYPRO CLEANLOAD NEXUS, Инструкция по установке и эксплуатации, Страница: 8 / 28

5.2 Cleanload Nexus Plumbing Layout
It is easiest to use Cleanload Nexus with sprayers that are already
fitted with an induction bowl and inductor (venturi). In this case,
a Tee fitting and a check valve (not included) should be fitted to
divert the suction line to the Cleanload Nexus as shown below.
!
CAUTION
When connecting Cleanload Nexus to a sprayer,
it must not be possible to shut off the suction line to Cleanload
Nexus while in use.
1
4
5
6
9
10
11 12
13
7
8
2
3
1 Container fitted with easyconnect cap 8 Sprayer induction area
2 Rinse water source 9 Shut off valve
3 Cleanload Nexus 10 Induction bowl
4 Calibrated Suction Hose 11 Circulation line from sprayer pump
5 Check valve 12 Inductor (venturi)
6 Check valve 13 To sprayer tank (without restriction)
7 Tee
NOTE : Flow from the coupler to the check valve should only be
downwards. If the venturi is located below the level of the Cleanload
Nexus, the check valve may be fitted close to the venturi.
OR
If the venturi is located above the level Cleanload Nexus the check
valve should be fitted into a part of the Suction Hose that is below
the Coupler.
if the Cleanload Nexus is mounted on the sprayer the Suction Hose
and the Rinse Water Supply Hose can be permanently plumbed into
the sprayer.
If it is not mounted on the sprayer it may be connected temporarily
during filling using suitable dry break connectors (not included).
For specific instructions on suitable connections for the sprayer
please refer to instructions provided by the sprayer manufacturer.
!
WARNING
The connection of Cleanload Nexus must be done
by professionals who are trained in repair and maintenance of the
sprayer.
!
WARNING
If Cleanload Nexus is not mounted correctly, it may
result in malfunctioning, spillage of agrochemical and contamina-
tion of the operator and/or environment.
CLEANLOAD NEXUS PNR-CN100-OIPM (10/12/21) ©2021 Pentair. All Rights.
8