#10
3.39
.65
.77
NOTE:
1. Tighten screw of all unused galleries to the specified torque above.
2. For multiple phase assemblies, join blocks together before installing on DIN profile.
cURus is a registered Recognized Component Mark of Underwriters Laboratories, Inc
UL is a registered trademark of Underwriters Laboratories, Inc.
CSA mark is a registered trademark of CSA Group Certification & Testing Inc.,
TECHNICAL SUPPORT
www.erico.pentair.com
IP8182_E
1 OF 2
INSTRUCTION SHEET
Pentair, CADDY, ERICO CADWELD, ERICO CRITEC, ERICO, ERIFLEX, and LENTON are owned by Pentair or its global affiliates. All other
trademarks are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.
WARNING:
Pentair products shall be installed and used only as indicated in Pentair product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.pentair.com
and from your Pentair customer service representative.
Pentair products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
completely
followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow Pentair's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and/or death, and void your warranty.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
UD400212CU(569051)
UD400212AL(569251)
© 2011-2016 Pentair All Rights
Reserved
