Beam Clamp
Tee Grid
1. Place on beam and
tighten screw securely.
(Approx. 20 in-lbs torque)
2. Press MC/AC cable into clip
1. Place inverted "T" tab
against acoustical tee bar
2. Push curved tabs back
over on opposite side
of tee bar and push down
3. Press MC/AC cable into clip
4. Note: An independent support
is needed to meet code
1. Snap clip onto metal stud or
screw clip to wood stud
2. Press MC/AC cable into clip
MAC2 snaps in half making 2 fasteners
for single runs of cable!
Parallel to Stud and up to 1/8" Flange
(Metal and wood studs)
Flange Application
Figure 4
Figure 3
Figure 2
Figure 1
Part Number Figure
Application
MAC2
1
Metal or wood stuf and 1/4" [6] flange
MAC2T
2
1 to 4 runs of MC/AC to metal stud
Part Number Figure
Aplication
MAC2ATA
3
1 or 2 runs of MC/AC to accoustical tee bar
Part Number Figure
Application
MAC2BC
4
1 or 2 runs of MC/AC to 1/8" [3] through 1/2" [13] flange
TECHNICAL SUPPORT:
www.erico.pentair.com
CFS242_F
INSTRUCTION SHEET
2 OF 4
© 1997-2017 Pentair All Rights Reserved
Pentair, CADDY, ERICO CADWELD, ERICO CRITEC, ERICO, ERIFLEX, and LENTON are owned by Pentair or its global affiliates. All other trademarks
are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.
