ELECTRICAL
INSTALLATION
This pump must be installed by a licensed or
certified
with
national or local codes and ordinances. Improper installation will
create a
in ury to users, installers, or others due to electrical shock, and may
also cause damage to property.
Always disconnect power to the pump at the circuit breaker before
servicing the pump. Failure to do so could result in death or serious
in ury to service people, users or others due to electric shock.
Read all servicing instructions before working on the pump.
e sure all electrical breakers, switches and automatic
controls are turned off before wiring motor.
2.
e
amps and phase of your particular pump motor. All of
this information is provided on the motor nameplate
label found on the side of the motor.
me familia
amps and phase of your particular pump motor. All of
this information is provided on the motor nameplate
label found on the side of the motor.
re that the supply voltage meets the
re uirements listed on the motor nameplate. If these
uirements are not met, permanent motor damage
may occur.
-P
An initial inspection is needed to ensure proper rotation
of the pump.
Once installed, momentarily cycle the power on and
then off. Note the rotation of the motor fan or shaft as it
come
or fan will match the rotation arrow noted on the pump.
before servicing.
clean and tight.
he wires to the appropriate length so they do not
overlap or touch when connected.
Permanently ground the motor using the green ground
ty
ground wire is connected to an electrical service ground.
2. The pump should be permanently connected to either a
circuit breaker, 2-pole timer or 2-pole relay.
Note:
If AC power is supplied by a GFCI circuit breaker,
the pump should be wired on its own independent circuit
unless the pump is operated in tandem with a Pentair salt
chlorine generator.
National Electrical Code and all other applicable national
AWG or larger solid copper bonding conductor is
lug to the bonding structure.
2. Connect the wire from the accessible bonding lug on the
motor to all metal parts of the swimming pool, spa, or hot
the inside walls of the swimming pool, spa, or hot tub.
bonding structure.
pump, be sure all electrical connections are
tight and all electrical and wiring compartment covers are
properly installed.
Note:
When the pump is started and stopped by
removing power with a relay or timer, a two-pole
device should be used to apply and remove power
to both POWER LINE TERMINALS.
Pentair offers GFCI breakers which offer
appropriate personal protection while meeting
2008 to current NEC Standards for Pool Pumps.
See Pentair product catalog for details.
Section P/N 350486 Rev. E 3/9/20
6
Ground
Screw
1/2” NPT Receptacle
for Liquid Tight
Connector
Bonding Lug
Motor Shaft
Flats for 1/2”
Wrench
BONDING
LUG
GROUND
SCREW
1/2” NPT RECEPTACLE
FOR LIQUID TIGHT
CONNECTOR
MOTOR SHAFT
FLATS FOR 1/2”
WRENCH
