1 Box contents
Make sure you receive all items of your shipment:
•
MVME3100 board
•
One printed copy of Quick Start Guide (this document)
•
One printed copy of Safety Notes Summary
When installing or servicing the system or accessories,
strictly observe the safety precautions in the
Safety Notes
Summary
. Ignoring these instructions can void the system
warranty and cause personal injury or property damage.
2 ESD
Electrostatic discharge and incorrect installation or
removal of the card can damage circuit or shorten its life.
Use a properly grounded ESD wrist strap or work in an
ESD-safe environment.
Connect to the ESD connector at the front or the rear of
the system.
3 Site preparation
1. Make sure that all environmental and power requirements
defined in the
Penguin Edge™ MVME3100 Installation and
Use
manual are met.
2. Remove all items from the box.
4 Configure hardware
To produce the desired configuration and ensure proper operation of
the Penguin Edge™ MVME3100, you may need to carry out certain
hardware modifications before installing the module. For more
information, refer to the
Penguin Edge™ MVME3100 Installation
and Use
manual.
5 Install the board
Note:
Before removing the housing cover make sure that the
system is shut down and disconnected from AC power.
1. Attach an ESD strap to your wrist.
2. Attach the other end of the ESD strap to an electrical ground.
The ESD strap must be secured to your wrist and to ground
throughout the procedure.
3. Remove any filler panel that might fill the slot.
4. Install the top and bottom edge of the MVME3100 into the guides
of the chassis.
5. Make sure the levers of the two injector/ejectors are in the
outward position.
6. Slide the MVME3100 into the chassis until you feel resistance.
7. Simultaneously move the injector/ejector levers in an inward
direction.
8. Verify that the MVME3100 is properly seated.
9. Secure the board to the chassis using the two screws located
adjacent to the injector/ejector levers.
10.Connect the appropriate cables to theMVME3100.
11. When the MVME3100 is installed in the chassis you are ready to
connect peripherals.
6 Connect peripherals
The following table lists the available connectors on MVME3100.
7 Complete installation
1. Verify that the board is installed and the power/peripheral
cables connected are appropriate for your system
configuration.
2. Replace the chassis or system cover, reconnect the system to
the AC or DC power source and apply power.
Penguin Edge™
MVME3100
Quick Start Guide
P/N: 6806800M29D JUNE 2022
Connector
Function
J4
PMC expansion connector
J11, J12, J13, J14 PCI mezzanine card (PMC) slot 1 connector
J21, J22, J23
PCI mezzanine card (PMC) slot 2 connector
J24
Boundary scan header
J25
COP header
J27
USB connector
J28
Front panel SATA connector
J29
Planar SATA connector
J30
Planar SATA power connector
J41B
10/100/1000Mb/s Ethernet connector
J41A
COM port connector
P1, P2
VME backplane connectors
J1A, J1B, J1C,
J1D
COM port connectors
J2A
10/100/1000Mb/s Ethernet connector
J2B
10/100Mb/s Ethernet connector
J10
PIM power/ground
J14
PIM I/O
P2
VME backplane connector
