Rev. 1.0
Penguin Computing
26
Figure 16: Installing the Cage Nuts
Step 2.
Mount both of the outer rails (C+D) into the rack (as shown in the figure below), and then use
8 standard pan-head screws (E) to fix them to the rack. Do not tighten the screws yet.
Figure 17: Mounting the Outer Rails into the Rack
Step 3.
If cable accommodation is required, route the power cable and/or Eth cable through either of
the outer rails.
Step 4.
Attach the switch to the left and right inner rails (A+B), by gently pushing the switch chassis
pins through the slider key holes, until locking occurs.
