pellenc HELION 3, Руководство по эксплуатации

Страница: 16 / 36

ELECTRIC HEDGE TRIMMER HELION 3
54_161520-B
4.6. DISCONNECTING THE BATTERY
1. Switch off the battery.
2. On the right chest strap of the harness, disconnect
the adapter cord from the quick connector of the
power cord (7) of the Electric hedge trimmer.
3. To remove the battery from the harness, refer to the
battery instructions and to the harness assembly in-
structions
5. USAGE
5.1. STARTING AND STOPPING THE ELECTRIC HEDGE TRIMMER HELION 3
5.1.1. START-UP OF THE TOOL
Caution
Check that the safety devices are running properly before starting work.
1. Check the working area (fences, posts, etc.)
2. Turn the rear handle to the correct position.
3. Connect the tool to the battery, refer to Section 4.5,
“Connecting PELLENC batteries to the tool ”.
4. Turn on your battery.
Note
The front handle safety throttle trigger must be re-
leased when the power is turned on. If this is not the
case, a flashing inside/outside LED appears and
the tool remains non-functional.
Note
If at least 1 indicator light on the handle is on, the
tool is powered up.
16