pellenc ALPHA 260, Руководство по эксплуатации

Страница: 19 / 27

PELLENC POWER TOOLS BATTERY ALPHA 260 / 520
56_133912-F
7. INCIDENTS AND TROUBLESHOOTING
7.1. SUMMARY OF CHARGE INDICATOR AND BEEP MESSAGES
Normal messages
Use
fixed
Battery charge level (0 to 99)
with 1 beep per minute
Battery empty, recharge immediately
flashing with 1 beep every 10 seconds
Stop using, recharge immediately
Flashing
Display off to avoid duplication with tool display
Charge
flashing every 4 seconds
Battery charge level (0 to 99)
fixed
Charging complete
Storage
flashing
Standby mode after 10 days of non-use
Degraded mode messages
Use
and alternately
Stop the tool; the battery temperature is too high
and and alternately
Stop the tool: Battery temperature too low
or or
Stop the tool: current too high
fixed
Stop the tool; the tool temperature is too high
Long beep and 1 short beep Stop the tool: intensity is too high
Long beep and 4 short beeps Stop the tool: Tool temperature too high
Charge
and alternately
Charge interrupted: Battery temperature too low
and alternately
Charge interrupted: Battery temperature too high
Fault messages
Use
and 1 beep every 2 minutes for 24 hours
Voltage too low after 3 hours of non-use. Recharge bat-
tery immediately
Charging
and alternating and continuous beep
Battery problem
and alternately
Charger problem
If your tool no longer works:
1. Turn the battery off using the on/off button (5).
2. Check the battery is charged, as shown on the gauge display (6).
3. Check the lead is connected and the cable thumb-wheel tightened.
4. Check that the battery is properly clipped to the tool.
5. Turn the battery on using the on/off button (5). Press the trigger and the safety lock (depending on the tool).
6. If the tool does not work, return the complete equipment in its original packaging to a certified repair service.
19