pellenc 56U00001, Перевод оригинального руководства пользователя, Страница: 14 / 40

CHARGING STATION PELLENC CHARGING STATION
56_136922-B
4. COMMISSIONING
4.1. INSTALLATION OF THE PELLENC CHARGING STATION
4.1.1. FIXING CHARGING STATION TO WALL
Important
The Charging station may be fixed only to a masonry type wall.
4 anchor studs are required to fix the charging station in place. Use anchor studs suitable for the type of wall
which will support the charging station:
• For a solid concrete wall (not subject to cracking) or a solid brick wall: RS PRO - REF 908-6895 or RAWL
FIXINGS - REF R-RBL-M06/10W.
• For a natural stone, breeze block or hollow block wall: RAWL FIXINGS - REF R-RBL-M06/10W.
1. Drill 4 x 12mm holes, 55mm deep at the positions specified below.
Note
For fixing to a brick wall, the studs must not be inserted in the mortar joints.
2. Remove any debris produced.
3. Remove the debris, and clean the holes thoroughly with a suitable brush or pump.
4. Remove the shelf from the charging station to make installation easier (see Section 4.5, “Installing chargers”).
14