Page 7
www.pelicanwater.com
(877) 842-1635
Installation
Sediment Tank Installation
Figure 3
When Leveling the Sediment Tank:
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
For a 1-6 Bathroom Tank:
1. Remove the gray cap from the top of the Sediment Tank.
2. Push Electronic Head onto Distributor Tube and screw it onto the Sediment Tank hand-tight.
3. Level the Sediment Tank if needed.
Tank Installation
1. Determine the size and material of your incoming water supply line from the incoming water
supply and choose the appropriate fittings required to connect it to the Bypass Valve.
CAUTION:
Do not over-tighten any of the fittings during installation.
Table 2: Bypass Valve Fittings
Note: The fitting above is designed with a ¼" give to allow for proper pipe alignment. It will not leak and
is intended to have some flexibility.
2. Install the fittings onto the inlet and outlet, following the arrows on the Bypass Valve and head.
3. Connect the incoming water supply to the fitting on the inlet side of the Bypass Valve.
4. Connect the outgoing water supply to the outlet side of the Bypass Valve.
Part
Description
Qty.
1" PVC Tail Adaptor for
Electronic Head Bypass
2
Distributor Tube
Electronic Head
Rev B —
Whole House Backwashing Sediment Filter System
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
