Page 6
www.pelicanwater.com
(877) 842-1635
Installation Overview
Figure 1
Pre-Installation
Bypass Valve Installation
Figure 2
If the Red Clips are in the slots (female opening of Electronic Head) remove them. Push the male O-Ring
side of the Bypass Valve into the female opening of the Electronic Head. Push the Red Clips back into the
slots to tighten.
Notice:
The Bypass Valve on the Electronic Head can be set to Bypass or Service by turning the knobs on the side
of the valve. If the holes are up and down then the tank is in the Bypass Mode. If the holes are side to side
then the tank is in the Service Mode. Do not remove the red clips from the Bypass Valve after connecting
to main water supply.
Outgoing
Water to
House
Wall
Incoming
Water
Supply
Wall
Discharge
Line
Electronic Head
Sediment Tank
Bypass Valve
Sediment Tank
Electronic
Head
Bypass
Valve
Rev B —
Whole House Backwashing Sediment Filter System
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
