VISION
100
THR
Page 20
USE AND MAINTENANCE MANUAL
Rev. 02-18
P1
Password:
type of protection.
(Active when PA is different from 0).
0 = Total lock. It is possible to
only see the temperature
and humidity setpoint.
1 = Locks access in 1st and
2nd level programmes.
Locks access in
germination cycle
amendment and
programmes amendment.
2 =Locks access in 1st and
2nd level programmes.
3 = Locks access in 2nd level
programmes.
3
PA
Protection password
0
– 999
0 = Disabled
0
dMY
Current date
dd:mm:yy
HMS
Current time
0:00...23:59
reL
release software
indicates the software version
(read only)
6
AUTOMATIC PROGRAMMES Pr1, Pr2, Pr3, Pr4, Pr5
To access the automatic programmes parameters, keep keys
START/STOP and
SET pressed for a few seconds (the function is active only if Cg=0).
1.
Using key
(
)
or key
(
)
select the program
to be amended. After having selected the
program, press the SET key to display the parameters.
2.
Using key
(
)
or key
(
)
select the parameter
to be amended.
3.
Amend the setting by keeping the SET key pressed and by pressing one of the keys
(
)
or
(
)
.
4.
Once configuration values have been set, to exit the menu press keys
(
)
and
(
)
simultaneously keeping them pressed for a few seconds, until the temperature value
appears again.
5.
Memorisation of the amendments made to the variables will happen automatically when
exiting the configuration menu. Exiting from the menu happens spontaneously after an
inactivity period or by simultaneously pressing keys
(
)
and
(
)
for a few seconds.
The following table represents any one of the Pr1, Pr2, Pr3, Pr4, Pr5 programmes.
CHAP. 5 - Data programming
5.11