Peg-Perego PRIMO VIAGGIO 360, Инструкция по эксплуатации

Страница: 16 / 116

16
must repeat the operation until the indicator turns
green.
6 To release the base from the vehicle seat, detach
the Isofix connectors from the hooks in the vehicle
by pulling the 2 front lateral levels on the base (1)
and the base in the travel direction (2).
Once the rear lateral levers are visible (fig_a),
release the base as shown in the figure (3).
7 Adjust the height of the supporting foot by
pressing the lever at the base of the foot until it
touches the vehicle floor.
IMPORTANT: Ensure that the leg is positioned
vertically and the foot firmly supported on the car
floor, even if the seat base becomes slightly raised.
IMPORTANT:
If there is a storage
compartment in the floor of your vehicle in the
area where the leg rests, open the compartment
lid and rest the leg on the base of the
compartment.
Car seat features
8 Once taken out of the box, the car seat is oriented
rear facing with respect to vehicle direction. A
lever located on the top of the base nose allows
the rotation of the car seat.
The car seat can be rotated 90° either side by
pulling on the lever. This allows an easy and safe
installation of the child. The two indicators located
on top of the base are red in this position.
IMPORTANT:
Do not keep the seat in this
position when the vehicle is in motion.
9 The car seat can be rotated forward facing.
IMPORTANT: Do not use the car seat forward
facing before the child's age exceeds 15 months.
To do this, push the button under the base and
release the safety device.
10 Use the handle to rotate the seat to the required
position until the indicator is green.
11 To adjust the car seat’s inclination, rotate the knob
until the seat is in the desired position.
12 The headrest must be adjusted to match the
child’s height. There are several positions.
To switch from a low to a higher position: pull the
tongue at the centre of the head rest (1) upward;
the head rest simultaneously lifts (2).
To switch from a high position to a lower one: pull
the lever in the upper central part of the headrest
upwards and, at the same time, push the headrest
down to the desired position.
When you have finished, slightly move the
headrest to check it is properly locked into place.
13 To guarantee greater safety, the car seat is
equipped with Kinetic Pods. Open the Kinetic
Pod on the side near the car door (fig_a). To close
it, pull the Kinetic Pod and fold it down into the
specific hollow (fig_b).
How to strap your child
14 The car seat uses a 5-point harness to protect
your child. Before placing the child on the seat.
Act on the central release button and pull the
straps, loosening the belts (fig_a). Do not pull the
shoulder pads.
Open the chest clip following the procedure
shown (fig_b), unfasten the safety belts by acting
on the red button of the crotch strap’s buckle
(fig_c).
15 Attach the buckles to the side elastics and pull the
crotch strap towards the front of the seat to make
room for the child. Make sure the sitting area is
free.
16 Place the child in the car seat and arrange the
harness over the child’s shoulders and waist. The
correct height for the safety belts is when the belt
slots on the backrest are at the same height of the
shoulders or above (green area), as shown in the
picture.
Make sure the straps are not in the red area.
17 Attach the safety straps by overlapping the two
belts (1) and inserting the metal hooks into the
crotch strap buckle until it clicks (2). Attach the
belt clip on the chest by combining the two parts
as shown in the picture (3).