ISSUED: 07-08-05 SHEET #: 055-9430-1
Visit the Peerless Web Site at www.peerlessindustries.com
3 of 9
For customer service call 1-800-729-0307 or 708-865-8870.
Drill two 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm). Attach projector mount assembly (
A
) with two
#14 x 2.5" (6 mm x 65 mm) wood screws (
F
) and two flat washers (
E
) as shown in
figure 1
or
figure 2
depending
on joist orientation. Tighten wood screws (
F
) using 3/8" (10 mm) socket wrench until projector mount assembly (
A
)
is firmly attached.
Skip to step 6.
Installation To Wood Joist Finished Ceilings,
Exposed Wood Joists, or Wood Beam Ceilings
F
F
A
WOOD JOIST
FRONT OF
MOUNT
E
E
FRONT OF
MOUNT
WOOD JOIST
A
figure 1
figure 2
• Tighten wood screws so that ceiling plate is firmly
attached, but do not overtighten. Overtightening can
damage the screws, greatly reducing their holding
power.
• Never tighten in excess of 80 in • lb (9 N.M.).
• Make sure that mounting screws are anchored into the
center of the studs. The use of an "edge to edge" stud
finder is highly recommended.
WARNING