ISSUED: 01-14-09 SHEET #: 056-9018-3 11-10-16
Visit the Peerless Web Site at www.peerless-av.com
2 of 9
For customer care call 1-800-865-2112.
Tools Needed for Assembly
•
stud finder ("edge to edge" stud finder is recommended)
•
phillips screwdriver
•
drill
•
1/4" masonry bit for concrete surface
•
5/32" bit for wood studs
•
level
• 3/8" (10 mm) socket wrench
• It is the responsibility of the installer to ensure that
the projector is properly ventilated. Feet of channels
are used to raise the mount off the projector surface.
CAUTION
Note:
Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings con
-
tained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, call Peer
-
less customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard
-
ware and components.
• Never exceed the Maximum UL Load Capacity.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power. See suggested torque values where applicable within these instructions.
WARNING
Table of Contents
Parts List
............................................................................................................................................................................3
Installation to Wood Joist or Wood Beam Ceilings
............................................................................................................4
Installation to Concrete Ceilings
........................................................................................................................................5
Flush Mount Application
....................................................................................................................................................
6
Installation to Extension Columns
.....................................................................................................................................7
Attaching Adapter Plate to Projector
..................................................................................................................................8
Attaching Adapter Plate to Projector Mount, Projector Alignment
.....................................................................................9
