11 of 33
ISSUED: 12-26-07 SHEET #: 055-9494-1
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-865-2112 or 708-865-8870.
If screws indicated in figure 11.1 are fully tightened,
loosen screws half a turn using allen wrench (
N
) to
allow for adjusting tilt, swivel and roll. Align projector
to the desired position and fully tighten screws.
Projector Alignment
11
SCREWS FOR TILT
ADJUSTMENT
(BOTH SIDES)
SCREWS FOR ROLL
ADJUSTMENT
(FRONT AND BACk)
SCREWS FOR SWIVEL
ADJUSTMENT
35° (+30°/-5°) TILT
20° (±10°) SWIVEL
20° (±10°) ROLL
fig. 11.1
ROLL ADJUSTMENT
FRONT VIEW
TILT ADJUSTMENT
SIDE VIEW
SWIVEL ADJUSTMENT
TOP VIEW
© 2008, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
• Do not loosen adjustment screws to the point they
become disengaged from the mount. Weight of the
projector should be supported in case of accidental
disengagement.
WARNING
Cut cable covers (
V
) to the length of inner channel (
C
) and outer channel (
B
) openings, leaving space for cables if
routed through channels. Snap cable covers into openings as shown.
10
CABLES
CUT TO
LENgTH OF
OPEnIng
V
CUT TO
LENgTH OF
OPEnIng
V
CABLES
CEILING INSTALLATION
WALL INSTALLATION
(ExCEPT FOR PPC MODELS)
CUT TO
LENgTH OF
OPEnIng
V
CUT TO
LENgTH OF
OPEnIng
V
C
B
C
B
Install Cable Covers
