CMYK
SINGLE
HEX
c32 m25 y25 k85
90% black
#363636
RGB
54 54 54
INSTALLATION GUIDE
Halo LED Mirror
Please read these instructions carefully before installation.
IEE Bathroom Zones
IMPORTANT
To ensure correct function of the sensor this product
MUST be installed with a minimum distance of 150mm
between the infrared sensor and any adjacent
worktop, surface, obstruction or tile trim.
•
When working at heights, please use a suitable platform to
work from.
•
Please note: For new installations, check for any electrical cables
or pipe work (gas/water) in the vicinity of the intended mounting
point before proceeding with the installation.
Ensure that the fixing location is able to take the weight of the
complete fitting.
•
•
Wear suitable eye protection when drilling. Be careful when
using power tools near water.
GENERAL
•
THIS PRODUCT CONFORMS TO UK SAFETY STANDARDS AND MUST BE
INSTALLED IN ACCORDANCE WITH CURRENT IEE WIRING REGULATIONS
AND BUILDING REGULATIONS (PART P).
•
THIS PRODUCT MUST BE EARTHED, AND SHOULD NOT BE CONNECTED
TO AN UNEARTHED CIRCUIT.
•
ENSURE THAT CONNECTIONS ARE TURNED OFF AT THE CONSUMER
UNIT OR FUSE BOARD BEFORE INSTALLING OR CARRYING OUT ANY
MAINTENANCE.
•
THIS PRODUCT IS FOR INDOOR USE ONLY.
•
THIS PRODUCT IS IP44 RATED AND CAN BE INSTALLED IN BATHROOM
ZONE 2 (AS DEFINED BY THE IEE WIRING REGULATIONS) AND BEYOND.
SEE BATHROOM DIAGRAM.
•
THE PRODUCT IS SUITABLE FOR INSTALLATION IN ZONE 2 OR HIGHER.
•
IF THIS PRODUCT FEATURES REPLACEABLE BULBS THEN REPLACE FAILED
BULBS IMMEDIATELY. ALLOW THE GLASS, LAMP AND FITTING TO COOL
BEFORE REPLACING.
HANDLE WITH CARE!
When unpacking never stand the unit on a hard
surface.Always lay flat on a soft surface.
To avoid the risk of electrocution, please turn off
the electricity mains supply before commencing
installation.
Please do not hang or drape clothing or material
over the mirror. LEDs can get very hot and this may
cause a fire risk.
Please do not place objects too close to the LEDs as
this will cause the object to burn or melt.
Do NOT strike mirror glass with hard or pointed items. It is
recommended that the product is cleaned with a soft, dry, non
abrasive cloth. Do NOT use cleaning agents or abrasive materials
on any type of finished surface.Do NOT allow moisture to come into
ventilated where possible.
COMPLIANCE
WIRING
This product is designed and manufactured in the Class 1 category,
meaning a ground wire is required.
COLOUR CODING
LIVE
Brown
Blue
Green & Yellow
zone
2
radius
zone
2
zone
2
225cm
zone
1
60CM
60CM
60CM
MIN
150mm
contact with the electrical components. Keep your bathroom well
BS EN 60598-1: 2008+A11: 2009, EN60598-2-1: 1989
This product complies with the following safety standards:
NEUTRAL
EARTH
201.40.0
5
Halo 201.40.0
5
800mm(Dia)
