Note:
The stem nut is located on the back of the tape support arm.
a.
Turn the stem nut to adjust.
b.
Lock the stem nut following adjustment.
2.
To adjust the tape tracking, release the two bolts that secure the arm to the
side plate.
a.
Adjust the jack screw; this is a recessed Allen head set screw located
between the two securing bolts.
b.
Relative adjustment of this screw with tightening of the upper and lower
arm bolts will lean the tape roll away from or toward the center line of
the tape head.
c.
Tighten the securing bolts before checking the tape centering.
d.
Readjust as necessary.
Note:
The exclusive "No Break Tape" feature fo the Dekka Tape head depends on the
edges of the tape overhanging the edges of the tape feed roller.
If extreme adjustments are needed to center the tape, this will
cause the "No Break Tape" feature to become ineffective and
cause poor performance. Verify the tape heads are not damaged
and the tape head mounting brackets have not been dislodged
from being on the machine center line.
CE35-T Case Erector
Operations Manual
3/2/2010
M-CE35T-2c Horiz Mag
104
o
T
w
o
H
